Start your beamtime
Here is a short introduction to start the experiment. Please open the following three interfaces to view, move, control and scan the required (pseudo) motors in order to execute your experiment during the beamtime.
Scanning, for XAS-measurements (or RIXSmaps): Scangui
RIXSmeasurements: Rixsclient
Liquid samples
The descrption about liquis jet is moved to LiquidJetChamber
Gas samples
The standard setup is “gas-jet” setup which use the same glass capilalry used in liquid setup. Switching between liquid jet and gas jet is done by changin tip parts of the rod. Some of innert gases (like Xe, Ne etc) can use gas cell setup using SiN window. Please note that inner gas like N2 is not innert enough after x-ray excitation and cause problem on SiN window (sudden burst of the window).